Vai al contenuto principale
Suchen Sie etwas anderes?
The Titan mini routers contain a movement detection system that allows we to send SMS alarms, make telephone calls or change a relay upon detecting movement.
- Accelerometer mode: this option activates the movement detection system with different sensitivity modes
- SMS: this option activates the sending of SMS messages in the event of detected movement
- Call: this option activates the telephone call option in the even of detected movement
- Phone numbers: list of numbers (separated by semi-colon) to which SMS messages will be sent and phone calls will be made
- Text SMS Alarm On: Text of the SMS alarm
- Pause between alarms: this field indicates the time (in minutes) between alarms. For example, a value of 60 means that no alarms or calls will be made for an hour after the last message was sent or the last call was made.
ADDITIONAL NOTES
- Once the configuration is complete, press the “SAVE CONFIG” button to save the changes. Remember that the router should be reset in order for the changes to take effect.
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
