Vai al contenuto principale
Suchen Sie etwas anderes?
MTX-Tunnel runs on MTX-Terminal modems. Internally there is a Cinterion 2G/3G/4G core, EHS6 for 3G models and ELS61 for 4G models.
Those modules use the AT command set, some of them are standardized and others are Cinterion proprietary. MTX-Tunnel can run just a few of them. Those are:
| AT > | OK |
| ATI > | Returns module firmware information |
| AT+CSQ > | Network GSM coverage |
| AT+CCLK? > | Current time output |
| AT^SSIO=X,Y > | Used to change the digital output X with the value Y |
| AT^SGIO=X > | Used to know the value of the digital input X |
| AT^SRADC=X > | Used to know the value of the analog input X |
| AT^SGPSR=0 > | Returns GPS position |
| AT^MONI > | Monitors information about BTS attached |
| AT^SMONI > | Monitors information about BTS attached |
| AT+CFUN=1,1> | Resets MTX-Tunnel |
| AT^SMSO > | Resets MTX-Tunnel (switches off and because MTX-Terminals is featured for it, it switches on automatically) |
Please read the AT Command manual from Cinterion for more information about the use, syntax and answers of those commands.
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
