Suchen Sie etwas anderes?
Table of Contents
OpenVPN
Please refer to Aplication Note from our website “AN2- OpenVPN configuration on MTX-Router-EOS”.
Server
Start Type: Startup while wan is up or system is up.
Auth Mode: Support pre-shared key authentication
System Generation Key: Randomly generated by the system
Pre-shared Key: Configure pre-shared key
Server mode: Tunnel mode or bridge mode
Peer Tun Ip/ Local Tun Ip: Tunnel ip address.
Peer Subnet/Peer Subnet Mask: Tunnel Subnet Mask
Port: Network port.
Tunnel Protocol: UDP or TCP.
Encryption Cipher: Standard of channel encryption
Hash Algorithm: Standard of hash algorithm
Client
Server IP/Name: IP/Name of server.
Port: Server port.
Auth Mode: Support pre-shared key authentication
Pre-shared Key: Configure pre-shared key
Server mode: Tunnel mode or bridge mode
Peer Tun Ip/ Local Tun Ip: Tunnel ip address.
Peer Subnet/Peer Subnet Mask: Tunnel Subnet Mask
Tunnel Protocol: UDP or TCP.
Encryption Cipher: Standard of channel encryption
Hash Algorithm: Standard of hash algorithm
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
