Vai al contenuto principale
Suchen Sie etwas anderes?
From this section we can configure the Titan router as a W-MBus hub, to collect data from W-MBus devices, pack them and send them to a web platform. Remember that our Titan router must have the RF card (optional) in order to use this feature.
It has a very detailed application note with examples of use, consult it for more information: AN21-RouterTitan-Wireless-MBus-Concentrator.pdf.
- Enabled: check this box to activate the “W-Mbus Concentrator of the Titan Router” feature
- Serial Port: select the serial port of the Titan router where the RF card (optional) is connected inside our Titan rotuer. Normally we must select “Serial Port USB”
- Mode: choose the W-MBus mode we need to use
- Time Window: indicates a temporary window (in minutes). Only one W-MBus data frame of each device received during said time window will be recorded
- Filter manufacturer: optional. It allows to introduce a manufacturer to receive only the data of equipment of this manufacturer. For example AMB, ARF…
- Logger: check this box if we want to save the W-MBus data to the internal logger for later upload to our Web platform via HTTP or FTP
ADDITIONAL NOTES
- Once the configuration is finished, press the “SAVE CONFIG” button to save the changes. Remember to restart our router for the new changes to take effect
Enter the “ethernet” or “modem” connection type:
For an ethernet configuration, make sure the IP parameters are compatible with server access according to the concentrator local network configuration. For an ethernet connection, the configuration must be compatible with the concentrator’s local network topology so that it can access the servers. This configuration is done from the “Networks” configuration page (see section 3.2.2.3: “Networks”).
For a modem connection, the modem configuration must be correct before a connection can be set up. This configuration is done from the “Modem” configuration page (see section 3.2.2.4: “Modem”).
The parameters for the servers to be configured are at least the following:
Therefore the following fields need to be configured: “Interface”, “Type”, “Server type”, “Address”, “Port”, “Login” and “Password”.
The other fields can be left at the default values subject to the directories having been properly created beforehand. See section 3.1.2: “Configuration files” for more details.
Wait. The concentrator will reboot using its factory configuration.
